Armed with the righteously sticky stuff, you next have to decide how to apply it to the slots in the nut.
A small dab between the end of the fingerboard and the nut will do the trick and permit easy removal that does not damage the bottom of the slot when removing.
Raising Action at the Nut There are good reason's to salvage an original nut if possible.
The nut can then be removed just as any other without having to make a new shim.Image 2 of 3, image 3.Under some of the most difficult circumstances, the nut must be sawn in half and literally collapsed in order to remove.In my opinion, they look awful.I have seen the made from wood veneer, paper even pieces of credit cards.Take your time, follow the steps, and do a good job.Nuts can be made from a variety of materials and require adjustment or replacement when wear and tear creates problems.Measure the height of the first two frets by laying a straight edge across them and sliding different combinations of feeler gauge blades under it until they touch the straight edge.To play properly in tune, the string's actual contact point should be at the front of the nut (the fretboard side).
Continue filing until your file contacts the gauges.
A minor adjustment (say.020) can make a very noticeable difference.
Sand base to sit properly in slot (some are angled).
Like I said, superglue is available in different "viscosities" or thicknesses.However, it is a different story when the nut sits in a channel.For proper string nut slot depths, use the feeler gauges.Phillips channel for more of his videos.Phillip McKnightwhose gear-centric videos we've featured on this here website many a timerecently released a new one that offers a quick jeux de machine a sous gratuit sans inscription francais and easy fix if your nut slot is cut too deep or shallow.0.002" or so can be added to the measurement as you go across the fingerboard toward the bass side, slightly raising the bass strings.Ready made nuts are available for installation on many instruments, however, adjustments to the slots must still be made.